Road Closures

Coker Road Closure Due to Increasing Water Levels

Please be advised that Coker Road from Kelly Road to the east side of Rice Bay will be closed tomorrow, Friday, May 9, due to the increasing water Level on Black Sturgeon Lake, specifically Rice Bay. The closure affects all vehicle and pedestrian traffic. 

The closure ensures the integrity of the road is maintained by preventing significant damage that could occur if travel on the Coker Road were to continue during this high water period. 

Following the closure, the Rice Bay water level will be...

Road Now Open at Veterans Drive Overpass Bridge

Please be advised that Veterans Drive, from Third Street North to the Harbourfront Roundabout, is now open to traffic.

Motorists can now travel through this area without restrictions.

Road Closure at Veterans Drive Overpass Bridge

Please be advised that Veterans Drive, from Third Street North to the Harbourfront Roundabout, will be closed today, Wednesday, May 7, for maintenance work on the overpass bridge conducted by CP.

Motorists are reminded to follow detours signs.

Thank you for your patience while this bridge maintenance is carried out by CP.

Matheson Street North Road Closure

Please be advised that Matheson Street North between Second Street North and Third Street North will be closed on Wednesday, May 7 from 8:00 a.m. to 5:00 p.m. to allow Synergy North to trim trees along their powerlines.

Thank you for your patience during forestry maintenance by Synergy North.

Road and Storm Sewer Project at Back Lane of Mikado Avenue

Please be advised that a reconstruction project at the back lane of Mikado Avenue from Tenth St North to Ninth St North will begin on Monday, May 5, to replace the existing asphalt and storm sewer. 

The work will take place from 7 a.m. to 7 p.m., Monday to Friday, unless specific site conditions require alternative hours. Access through the construction zone will be limited at times. 

We anticipate the reconstruction project will be completed by the end of June. 

If you have any questions or concerns...