News

Notice of Complete Application and Public Meeting for Zoning By-law Amendment D14-25-04

The Corporation of the City of Kenora  Notice of Complete Application and Public Meeting for a Zoning By-Law Amendment   Section 34 of the Planning Act, RSO 1990

Take notice that the Council of the Corporation of the City of Kenora will hold a Public Meeting to consider a proposed Zoning By-law Amendment under Section 34 of the Planning Act (RSO 1990), as described below and shown on the attached map.

File: D14-25-04

Location: Vacant land north of Fourth Street South, legally described as Lots 2 through...

Road Now Open at Veterans Drive Overpass Bridge

Please be advised that Veterans Drive, from Third Street North to the Harbourfront Roundabout, is now open to traffic.

Motorists can now travel through this area without restrictions.

Road Closure at Veterans Drive Overpass Bridge

Please be advised that Veterans Drive, from Third Street North to the Harbourfront Roundabout, will be closed today, Wednesday, May 7, for maintenance work on the overpass bridge conducted by CP.

Motorists are reminded to follow detours signs.

Thank you for your patience while this bridge maintenance is carried out by CP.

Matheson Street North Road Closure

Please be advised that Matheson Street North between Second Street North and Third Street North will be closed on Wednesday, May 7 from 8:00 a.m. to 5:00 p.m. to allow Synergy North to trim trees along their powerlines.

Thank you for your patience during forestry maintenance by Synergy North.

Street and Bridge Washing Program

Please be advised that street and boulevard washing in the downtown core has begun to remove winter sand and debris. Once the downtown core is complete, crews will move on to municipal bridges. 

City crews will work from 4:00 a.m. to 6:00 a.m. on weekdays to minimize traffic disruptions. 

Motorists are asked to exercise caution around our crews as they carry out this work. Please reduce your speed in work zones, stay alert for signage, and follow traffic control instructions. 

Thank you for your...